How do I conduct an activity?

Congratulations on completing your registration on the CITYPLAY app! Now, we will guide you step-by-step on how to conduct an activity and view your sessions' data on the app!

NOTE:

• CITYPLAY's automatic detection and analysis are not affected by the different types of playing surfaces or weather conditions (indoor or outdoor pitches).
• You can only record one session at a time!
• Your phone is not needed to start and end a session.

STEP 1 - Make sure your sensors are ready to record an activity

Refer to this article to make sure that your sensors are ON, charged, and ready to record an activity. 

STEP 2 - Start an activity

1. Remove both sensors from the CITYPLAY case (this action triggers your session to start).
2. Your sensor lights should now blink BLUE.
3. A blinking BLUE light indicates that your activity is automatically being recorded.
4. You can also verify that your session is recording from the 'Activities' screen on your app (your sensors and phone must be within Bluetooth reach to see this indication).
   • Open the CITYPLAY app.
   • Go to 'Activities'.
   • On the top right of the screen, the 'Sensor Status' should say: 'Rec'.

STEP 3 - Meet CITYPLAY's minimal activity threshold

It is extremely important to be aware that there is a minimal activity threshold that must be met for the CITYPLAY system to register your performance as a valid activity. Failure to meet the threshold requirement will result in an unrecognizable session that will automatically be deleted by our system.

CITYPLAY's activity threshold requires you to complete a minimum of:

In addition to at least one of the following: 

     OR     

STEP 4 - Strap your CITYPLAY device onto your boots

Watch this video to learn how to strap your CITYPLAY device onto your boots. 

1. Insert the right sensor into the right strap (Marked as R gray).
2. Insert the left sensor into the left strap (Marked as L pink).
3. Verify that the sensor light is visible through the smaller strap hole.
4. Place the right strap onto your right boot.
5. Place the left strap onto your left boot.

STEP 5 - End an activity

1. Remove your sensors from your straps.
2. Place your sensors back inside the CITYPLAY case (this action triggers your session to end).
3. Your sensor lights should now blink white.
4. A blinking white light indicates that your activity's data is stored in the sensor and is ready to be synced onto the app.
5. NOTE: Only one session can be stored on your sensors at a time. Therefore, after conducting a session, you must first sync your recent session's data onto the app, and after that, you can begin your next session. 

STEP 6 - Sync your activity's data onto the app

1. Open the CITYPLAY app on your mobile device.
2. Make sure your Bluetooth is ON.
3. Keep your phone and sensors in close proximity to one another. 
4. Make sure you have a stable internet connection.
5. Your new activity will automatically pop up on your app.
6. Select the activity type: Match or Training. 
7. Complete your activity details.
8. Now, analyze your session's data!

Suggested articles to help you get started: 

1. Stats Glossary, explained
2. Light statuses, explained
3. What are CITYPALY'S two main activity types?
4. Which statistics are for Match and Training sessions?
5. 6-hour session limit, explained